Lab Report Example | Topics and Well Written Essays - 1250 words

Lab Report ExampleYoungs Modulus is the account of the materials stiffness. The Youngs Modulus indicates the extent to which a material stretches as a result of stress. Mathematically, the Youngs Modulus can be show asIn two graphs below shows the experimental results of entertains of stress plotted against strain (stress-strain graph) for steel and aluminium. From the two graphs, the Youngs modulus for the two materials marque and aluminium were determined.Hooks law of elastic states that Load or Force is directly proportional to the extension of the material so long as the given load does not exceed an elastic limit. This relationship is often expressed as the word done or Elastic Potential capacity required to stretch a material and it is equal to the area of the Tension/extension graph and can be expressed asWe therefore, used the in a higher place principle to find the area under the curve. This way, the area is the cross section area of the steel which is 10.12 mm2 (12.4 9 mm X 0.81 mm). Equally, the modulus of elasticity of steel was found from the stress-strain graph asThe results of this experiment shows that steel has a higher Modulus of cinch compared to Aluminium. Based on the results of this experiment the Modulus of Elasticity of Steel is , which is higher to the Aluminiums Modulus of Elasticity 70.8KN/mm2. This are in conformity with what has been found in literature. Studies show that for steel, the Modulus of Elasticity is 180 x 109N/m2 which is equivalent to 180 KN/mm2 (Krueger, 2007). On the other hand, literature gives the value for Modulus for Elasticity for Aluminium as 69x 109N/m2, which is an equivalent of 69Nmm2 (Krueger, 2007). This clearly demonstrates that modulus of elasticity for Steel is higher than that for Aluminium. However, what is appalling is that the experimental Modulus of Elasticity values (both steel was and aluminium) are passably higher than what has been documented. To ascertain the accuracy of